Article explaining some of the details.
https://www.mlb.com/news/abs-challenge-system-mlb-2026
How is the ABS strike zone measured?
Like the plate, it is 17 inches wide. The top end of the zone is at 53.5% of the player’s height, while the bottom is at 27% of the player’s height. The depth of the zone is 8.5 inches from both the front and back of the plate to its center.
How does this compare to the human umpire zone?
The umpire-called zone has generally been more rounded and more lenient to pitchers, with a 55.6% max up top and 24.2% minimum at the bottom.
As an example of the impact this can have on a key call, MLB research found that, in 2-2 counts, the umpire-called zone was 449 square inches, while the ABS zone was 443 square inches.
Is the ABS strike zone three-dimensional?
No. Though the rulebook defines the strike zone as a cube, the ABS strike zone is two-dimensional. A three-dimensional version was initially tested, but it allowed breaking balls to nick the edges of the zone, leading to inconsistency in strike calls.
Why is the ABS strike zone over the middle of the plate instead of the front?
In the past, TV broadcasts featured a zone set at the front of the plate. But similar to the 3D testing, having the zone over the front of the plate in initial testing produced odd outcomes, such as slow curveballs that clip the very front edge of the zone and land in the dirt being ruled a strike, even though no one who watches baseball would agree.
How does the ABS zone account for different player heights?
All position players in Spring Training camps have their heights measured by a team of independent testers conducting manual measurements and by representatives from a research institute using biomechanical analysis to confirm the manual measurements and safeguard against potential manipulation.
Players are measured standing straight up without cleats.